GKN Automotive‘s new light-weight modular propshaft was designed to reduce NVH in greater load applications. It can seem a considerable way in engineering and NVH terms from top European vehicles like Audi’s A5 and A7 to light trucks, but GKN Automotive has bridged that gap with its latest light-weight all wheel modular propshaft. Many pickups suffer a substantial number of undesirable NVH emanating from the front propshaft, with both the connecting shaft positioned below and close to the passenger cabin worldwide or Curriculum Vitae joints along with the connecting shaft positioned below and close to the passenger cabin. But now GKN Automotive has re distinguished, its superior auto driveline system to an entirely different car category.
With a traditional truck front propshaft, the level of noise entering the cabin is perceived as a drone, clarified Michael Miller, GKN’s propshaft merchandise technology manager. We have worked on applications of the newest technology where NVH cabin levels have been drastically reduced. Favorable results come from a combination of joints utilized in our light-weight modular front propshaft. The GKN driveshaft abandons the traditional Rzeppa type layout where joints face open at the exact same direction. Instead it utilizes an opposed track designed to better balance the joint’s internal forces. Its horizontal, the elimination of heat generating sphere surfaces of the cage to outer race, therefore enabling high speed CVJs to operate more efficiently under maneuver the balls, Miller said, permitting new propshaft also incorporates what Miller describes as sophisticated sealing greater angles typical of front propshafts.
The new propshaft also incorporates what Miller describes as advanced sealing procedures developed to safeguard components in extreme conditions and largely extend, lifecycles.
This has been accomplished utilizing over wrought technology, which chemically bonds rubber to steel substrate, Miller clarified, or automatically crimping of rubber to steel press or mechanical crimping of rubber on steel components. The sealing system employs developed in collaboration with Zeon Chemicals. Miller reported the big development program struggle for GKN was substantial performance improvement with decreased weight. The purpose was to apply relatively sophisticated technology seen in other sections, but never implemented to the entire size truck and SUV segment, where large load and robustness are critical, he explained.
We’d to ensure the CVJs stay lubricated all through their life span despite the extreme use of the vehicles. The two CVJ on one part front propshaft utilize over shaped boot designs that eliminate traditional sealing media components like O rings and gaskets by an integrated seal design in conjunction with the boot. The distinction between the truck and auto applications? . It boils to the required operating angles. The Audi applications are low, articulation angle applications. The new countertrack is an optimization of demanded a greater continuous joint running angle. The new countertrack is an optimization of port, sealing system and component complexity reduction for these new applications demands. Several models that now incorporate the scalable system are based on GM‘s 2019 T1XX platform.
Read another article on SAE-UK, shop safety Auto Parts products and DOT Approved h4 led bulbs for headlight from one of our 17,000 SAE membership for routine maintenance and repairs. For more information on diagnosing and repairing car light problems, chat with a knowledgeable expert at LedoAuto.